Idiomas disponibles
Idiomas disponibles
Searing Burner
7
Remove the plastic packaging from the searing burner valve. Remove the searing burner grate from the
searing burner shelf.
Remove the 2 pre-installed screws from the valve control stem and set them aside. (A & B)
Loosen the searing burner to insert the gas valve. First, loosen and remove the screw attaching the
electrode (C) to the shelf and set it aside, then loosen and remove the 2 screws holding the searing burner
in place. (D)
Insert the gas valve into the searing burner. (E) Insert the valve control stem through the hole in the fascia.
(F) Install the 2 previously removed valve control stem screws, but do not fully tighten until the bezel has
been attached to the fascia.
Reattach the searing burner to the shelf with the 2 previously removed screws. (G)
Reattach the electrode to the shelf with the previously removed screw from the searing burner. (H)
Insert the bezel openings over the valve control stem and the 2 screws. (I)
Slide the bezel down onto the screws. Make sure that the black mark on bezel is vertical.
Tighten the 2 screws to secure the bezel to the fascia. (J)
Push the control knob onto searing burner valve stem. (K)
Place back the searing burner grid. (L)
Connect both igniter wires to the igniter module on the left side of the searing burner shelf fascia.
To connect, push the igniter wire tips into the slots on the pins in igniter module. (M)
Slide the searing burner drip box into the drip box bracket. (N)
Unscrew the igniter cap from the control panel. Insert (1) AA battery (provided in the blister pack) into the
battery slot with the positive end (+) facing outward. Screw the igniter cap back onto the fascia. (O)
25
