Replacing The Cutting Blade; Checking And Replacing The Wear Guard - Stihl FC 56 C Manual De Instrucciones

Replacing the Cutting Blade

1
A
B
C
Do not attempt to straighten or weld a
bent or cracked blade – it may break – it
must be replaced – see "Mounting the
Cutting Blade".
STIHL recommends you use only the
following original STIHL cutting blades:
Length Thick - Marking
ness
200 mm 2.4 mm 4133 / 01
200 mm 3.8 mm 4133 / 02
Do not resharpen the blade.
Replace the blade (1) if its
N
length (A) is no longer sufficient to
maintain the necessary ground
clearance (B) and obtain the
required depth of cut (C).
Checking Out-of-Balance
To avoid out-of-balance:
Have your dealer check the blade
N
for out-of-balance on a STIHL
balancer (special accessory) –
STIHL recommends an authorized
STIHL servicing dealer. If blade is
out-of-balance, fit a new one – see
"Mounting the Cutting Blade".
FC 56 C
Checking and Replacing the
Wear Guard
Checking the protection against wear
1
2
Before starting up the machine,
N
check that the protection against
wear (1) is not damaged
Replace the protection against wear
N
at the latest when the gearbox (2)
becomes visible (arrow)
NOTICE
If worn deflectors are not replaced in
time, this can cause serious damage to
the gearbox.
Replacing the protection against wear
4
5
Remove the blade – see "Fitting the
N
blade"
Unscrew screws (4)
N
Replace the protection against
N
wear (5)
Screw in and tighten screws (4)
N
Fit the blade – see "Fitting the
N
blade"
English
4
27