Tabla de contenido
Idiomas disponibles
Idiomas disponibles
English / USA
Replacing the Skirt
1
3
2
4
Removing the skirt
:
Release and remove screw (1)
along with washer (2).
:
Pull the skirt (3) off the lug (4) and
out of the deflector
5
3
Position of skirt
:
Position the skirt (3) correctly in
relation to depth wheel (5):
If wheel is on left, the skirt must
project to the right.
28
3
4
Fitting the skirt
:
Push the skirt (3) into the slot in the
deflector until it can be engaged on
the lug (4).
:
Fit the washer on the screw.
:
Insert screw and tighten it down
firmly.
Replacing the Edger Blade
1
A
B
C
A bent or cracked blade must not be
straightened or welded – it may shatter.
Such blades must be replaced – see
"Fitting the Edger Blade".
STIHL recommends you use only
genuine STIHL edger blades – see
"Special Accessories".
:
Replace the blade (1) when its
length (A) is no longer sufficient to
maintain the necessary ground
clearance (B) and obtain the
required depth of cut (C).
To avoid out-of-balance:
check blade on a STIHL balancer –
see "Special Accessories".
Do not resharpen the blade!
FC 55
Capítulos
Tabla de contenido
