Idiomas disponibles
Idiomas disponibles
Additional steps
Play records
Switch the operating switch to PHONO. The display and
1.
power light light up; the screen shows "PHONO".
2.
Place a record on the turntable.
3.
Before playing a single with a larger hole, place the adap-
ter ("puck") on the spindle.
NOTE
Make sure that the record is free of dust. You can find appropriate record-cleaning
brushes and cloths in specialist retail shops.
4.
Select the desired speed with the speed controller:
33 rpm for LPs;
45 rpm for singles.
(Refer also to Check and adjust play speed, Page 13.)
5.
Raise the pick-up arm by moving the lever to the
6.
Move the pick-up arm inwards over the edge of the record or
over the point from which you want to play the record. The turntable starts to
rotate.
7.
Lower the pick-up arm by moving the lever to the
The needle goes down and the record starts to play.
8.
Control the volume on the connected device.
9.
At the end the pick-up arm returns automatically (refer also to Adjust the move-
ment radius of the pick-up arm, page 13).
10. If you want to pause the playback, use the lever to raise and lower the pick-arm.
11. At the end of the side of a record press the EJECT button to replace the pick-up
arm on the holder. With EJECT you can stop the playback at any time.
12. Set the operating switch to the OFF position to switch the
device off.
12
Lay the turntable mat onto the turntable.
Remove the protective cap from the pick-up arm.
Please keep this protective cap safe.
position: pick-up arm up.
position: pick-up arm down.
English
