Idiomas disponibles
Idiomas disponibles
NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING!
NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING!
NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING!
Cleaning
•
Wipe surfaces clean with mild dish detergent or baking
soda.
•
For stubborn surfaces use a citrus-based degreaser and a
nylon scrubbing brush.
•
Rinse clean with water.
NOTE: While cleaning the unit, be sure to keep the area
around the burner and pilot assembly dry at all times. Do
not submerge the control valve assembly. If the gas control
is submerged in water, do NOT use it. It must be replaced.
TIP: Use high-quality automobile wax to help maintain the
appearance of the heater. Apply to exterior surfaces from
the pole down. Do not apply to emitter screen or domes.
Maintenance
•
Keep exterior surfaces clean.
•
Air flow must be unobstructed. Keep controls, burner
and circulating air passageways clean. Signs of possible
blockage include:
»
Gas odor with extreme yellow tipping of flame.
»
Heater does NOT reach the desired temperature.
»
Heater glow is excessively uneven.
»
Heater makes popping noises.
NOTE: In a salt-air environment (such as near an ocean),
TROUBLESHOOTING
Symptom
Burner doesn't stay lit
1.
Burner doesn't light
1.
2.
3.
4.
5.
Burner flame is low.
1.
Note: Heater operates at
2.
reduced efficiency below
40°F.
Carbon buildup
1.
Possible Cause
Thermocouple and tilt switch are broken.
Gas pressure is low.
Blockage in orifice and gas line.
Blockage in venturi tube.
Distance between the igniter pin and thermocouple is
incorrect.
No sparks appear when lighting.
Outdoor temperature is less than 40˚F and tank is less
than 1/4 full.
Control knob is not fully "ON" or there is a blockage.
Dirt or film on reflector and emitter.
Tabletop Patio Heater
corrosion occurs more quickly than normal. Frequently check for
corroded areas and repair them promptly.
Storage
Between uses or during periods of extended inactivity:
•
Turn control knob to "OFF".
•
Disconnect LP cylinder and move to a secure, well-location
outdoors.
•
Store heater upright in an area sheltered from direct
contact with inclement weather (such as rain, sleet , hail,
snow, dust and debris).
NOTE: Never leave LP gas tank exposed to direct sunlight
or excessive heat.
•
If desired, use cover (K) to protect the heater and help
prevent buildup in air passages.
CAUTION: Wait until heater is cool before covering.
1.
Press down and rotate the control knob,
holding it down for at least 30 seconds,
then release. If the burner doesn't stay lit,
contact customer service.
1.
Turn control knob to "OFF" position and
replace cylinder.
2.
Clear blockage.
3.
Clean venturi tube.
4.
Adjust the distance between igniter pin and
thermocouple to 0.12-0.2 in.
5.
Check whether igniter wires are properly
connected to the igniter.
1.
Turn control knob to "OFF" position and
replace with a full cylinder.
2.
Check control knob setting and check
burner and orifices for blockage.
1.
Clean reflector and emitter.
9
Operating Instructions and Owner's Manual
Corrective Action
