Idiomas disponibles
Idiomas disponibles
NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING!
NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING!
NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING!
OPERATING INSTRUCTIONS
Before Lighting
This heater was designed and approved for OUTDOOR USE
ONLY. DO NOT use it inside a building, garage or any other
enclosed area.
Make sure surrounding areas are free of combustible materials,
gasoline and other flammable vapors or liquids.
Ensure there is no obstruction to air ventilation.
Be sure all gas connections are tight and there are no leaks.
Be sure the access panel is clear of debris.
Be sure any component removed during assembly or servicing is
replaced and fastened prior to starting.
Checking For Leaks
Make 2-3 oz. of leak solution by mixing one-part liquid dish
soap with three-parts water.
1.
Make sure control knobs are off.
2. Spoon or brush several drops (or use squirt bottle) of the
solution onto the gas regulator and tank connection.
3. Turn on gas cylinder valve. Inspect the connections and
look for bubbles.
a. If no bubbles appear, the connection is safe.
b. If bubbles appear, there is leakage. Loosen and re-
tighten this connection. If it still leaks, please call
customer service.
NOTE: Whenever gas connections are loosened, removed or
re-assembled, you must perform a complete leak test.
Lighting Instructions
1.
Ensure the control knob is in the "OFF" position.
2. Push in control knob and rotate it to the "ON"
position. This will activate the built-in igniter and light
the burner. If necessary, keep depressing and rotating
knob until burner lights.
3. Once burner is lit, hold control knob in for at least 30
seconds and release.
4. If burner does not stay lit, turn to "OFF" position and
wait 5 minutes and repeat steps 2 and 3.
5. If burner does not light, use a lighter positioned
against the bottom of emitter screen at burner
location.
6. Once burner is lit, rotate control knob to desired
heating level. If you experience any issues while
attempting to light the item, turn off the heater and
gas supply and refer to TROUBLESHOOTING.
CAUTION: Avoid inhaling fumes emitted from the heater's
first use. Smoke and odor from the burning of oils used
in manufacturing will appear. Both smoke and odor will
dissipate after approximately 30 minutes. The heater should
NOT produce thick black smoke.
Re-lighting Instructions
NOTE: For your safety, control knob cannot be turned on
without first depressing control knob in off position and then
rotating to on.
1.
Turn gas control knob to off.
2. Wait at least 5 minutes to let gas dissipate before
attempting to re-light burner.
3. Repeat "Lighting" steps 2 and 3.
1
7
Tabletop Patio Heater
Operating Instructions and Owner's Manual
OF
F
ON
HIG
H
OFF
LO
ON
W
HIGH
LOW
