Idiomas disponibles
Idiomas disponibles
NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING!
NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING!
NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING!
When Heater is "ON":
Burner will display slight blue flame at the bottom and strong
yellow at the top. The color is more visible at night.
If only yellow flame is detected, turn off heater and gas supply
and refer to TROUBLESHOOTING. Visually check burner flames
at each use and make sure flame height matches illustration to
the right.
Turning Off
1.
Rotate gas control knob to "OFF" position.
NOTE: Burner will likely make a slight popping sound when
extinguished.
2. Disconnect LP-gas tank after use. Rotate LP-gas tank to
horizontal position, unscrew it counterclockwise until it is
loose. Store the LP-gas tank in a proper location.
3. Close door on housing assembly.
NOTE: After use, some discoloration of the emitter screen is
normal.
CARE AND MAINTENANCE
•
Abrasive cleaners will damage this product.
•
Never use oven cleaner to clean any part of heater
•
Do not clean any heater part in a self-cleaning oven. The
extreme heat will damage the finish.
•
More frequent cleaning may be required as necessary.
It is imperative that control compartment, burners and
circulating air passageways of the heater be kept clean.
•
Spiders and insects can create a dangerous condition that
may damage heater or make it unsafe. Keep burner area
clean of all spiders, webs or insects. Clean burner holes by
using a heavy-duty pipe cleaner. Compressed air may help
clear away smaller particles.
•
Inspect heater before each use.
•
Have heater inspected annually and repairs should be made
by a qualified service person.
•
Check heater immediately if any of the following conditions
exist:
a. The smell of gas in conjunction with extreme yellow
tipping of burner flames.
b. Heater does not reach proper temperature.
c.
Heater's glow is excessively uneven.
d. Burner makes popping noises during use.
NOTE: A slight pop is normal when burner is
extinguished.
•
Carbon deposits may create a fire hazard. Keep dome and
emitter clean at all times.
•
Do not clean heater with combustible or corrosive cleaners.
Use warm, soapy water.
•
Do not paint engine, engine access panel or dome.
•
This heater should be thoroughly cleaned on a regular
basis.
•
After a period of storage and/or non use, check for leaks,
burner obstructions and inspect for any abrasion, wear,
cuts to the hose.
•
Some 1-lb. cylinders may form frost when near empty,
which is normal and not a defect.
•
Periodically check the hose located within the confines of
the cylinder housing for damage.
2
8
Tabletop Patio Heater
Operating Instructions and Owner's Manual
