YATO YT-36725 Manual página 8

The assembly and settings made in the factory should not be
changed. Attempting to change settings or design of the set as
well as disassembly of some parts or using them for purposes
other than their intended use may be dangerous.
Do not use the appliance if it has damaged or worn seals. Do
not use the appliance which is leaking, damaged, or not func-
tioning properly. Do not use the appliance that shows any signs
of damage.
Close the appliance valves before refi lling the gas. Do not smo-
ke tobacco while changing a container.
It is required that the appliance is used in well-ventilated areas,
in accordance with the national requirements
regarding: supply of combustion air; avoidance of dangerous
accumulation of unburned gases.
The appliance should be used away from fl ammable materials.
The distance between the burner outlet and adjacent surfaces
(walls, ceilings) must be at least 5 metres. The burner outlet
must never be pointed in the direction of people or animals.
Gas containers should be refi lled in well-ventilated areas, prefe-
rably outdoors, away from any fi re sources such as open fl ames,
gas pilot burners, electric heaters and away from other people.
If the appliance is leaking (gas odour), take it immediately
outdoors to a well-ventilated place without fi re, where the leak
can be located and removed. If you want to check for leaks in
your appliance, do so outdoors. Do not try to detect leaks using
a fl ame; use soapy water.
The burners' outlets heat up to a high temperature during ope-
ration. Keep children and unauthorised persons away from the
appliance.
Before starting refi lling the gas, make sure that the burners are
extinguished.
Do not modify the appliance.
If it is necessary to send the appliance to the manufacturer or
service centre, cool the device, empty the container of the gas,
then pack the appliance in a paper unit packaging and secure
it according to the chosen type of transport. It is forbidden
to send the appliance with a container fi lled with gas. The
transport of dangerous goods is subject to restrictions.
Do not put away the ignited burner. Be careful not to heat the
containers or burn the hoses. Replace accessories if necessary.
Do not operate in closed spaces; ensure good ventilation. Work
only in a clean place, away from fl ammable or greasy materials.
8
O R I G I N A L I N S T R U C T I O N S
EN
Use eye protection equipment. Wear non-greasy clothing. Avo-
id inhaling welding/soldering fumes.
During operation, observe the recommendations regarding:
gas consumption (at normal settings) for each accessory and
the containers shelf life.
Empty the gas container if the set will not be used for an exten-
ded period of time or if transported by a vehicle.
Store and transport containers in a standing position. Keep
away from children.
Use only specifi ed spare parts. Never use the set with a da-
maged part.
Service centre address: TOYA SA, ul. Sołtysowicka 13-15, 51-
168 Wrocław, Poland.
In the event of a gas leak, immediately extinguish the burner
fl ame and get away from any sources of fi re and high tempe-
rature. Follow the information in the product safety data sheet
accompanying the gas container. Head upwind. Isolate the
contaminated area, do not allow bystanders. Try to stop or at
least limit the release to the environment as far as possible.
Use appropriate respiratory protection. Spray water mist to mi-
nimise and limit gas spread.
APPLIANCE OPERATION
Gas refi lling (II)
Refi lling should take place outdoors or in a well-ventilated area
away from sources of fi re or excessive heat. Maintain distance
from bystanders.
Close the gas valve by moving the regulator knob as far as
it will go in the direction marked with the minus symbol and
make sure that the magneto button is not locked in the pressed
position. Use gas of good quality. The gas container should be
equipped with an adapter adapted to the valve type.
Point the burner with the valve upwards. Apply the outlet of the
gas container to the valve. Press the cylinder against the valve.
Fill until fi rst signs of overfi lling; gas will start to escape from
the connection between the burner and the gas container. Put
the burner down for a few minutes to stabilise the gas pressure
in the container.
Appliance operation
Make sure that there are no gas leaks, then turn the gas re-