Idiomas disponibles
Idiomas disponibles
HOW TO OPERATE
REMOVE AND REPLACE SOLUTION RESERVOIR:
1. Grasp solution reservoir under handle and press clean solution reservoir latch (Diagram 1).
2. Tilt solution reservoir away from cleaner and remove (Diagram 2).
3. Unscrew measuring cap from back side of solution reservoir (Diagram 3). Fill measuring cap with solution 2 times (approximately
4 oz.)(Diagram 4). Fill remaining solution reservoir with hot tap water (Diagram 5). Replace measuring cap.
NOTE: Use only Dirt Devil" Carpet & Rug Shampoo. Using other cleaning solutions may cause excessive foaming. Excessive
foam will cause the float to shut off the vacuum prematurely. Using other cleaning solutions will void your warranty.
4. Place bottom of solution reservoir into cleaner and rotate top into position until the lever snaps into place (Diagram 6).
CARPET CLEANING
NOTE: Never leave unit unattended with power on. Turn OFF when emptying and filling reservoir. Do NOT oversaturate the carpet.
IMPORTANT: FOR BEST CLEANING RESULTS USE STEADY, MODERATE FORWARD AND BACKWARD MOTION.
1. Plug cord into electrical outlet.
2. Turn power on (Diagram 7).
3. Step on handle release pedal (Diagram 8), to put unit in cleaning position.
4. While depressing solution spray trigger, pull unit in backward motion (Diagram 9). Release trigger and push unit forward in same path
to remove dirty water and solution from carpet. (For heavily soiled areas, repeat if necessary)(See page 8).
5. When dirty water reaches the max fill line on dirty water tank, empty dirty water.
IMPORTANT: IF THE SOUND OF THE MOTOR CHANGES TO A HIGH PITCH, THIS INDICATES THE DIRTY WATER TANK IS FULL
AND MUST BE EMPTIED. A VISUAL INDICATOR IS WHEN THE BLUE FLOAT HAS RISEN TO THE TOP OF THE DIRTY WATER TANK.
