Idiomas disponibles
Idiomas disponibles
Battery Connection
To Connect the Inverter to Batteries:
1. Locate the positive (+) red and negative (-) black terminals on the
DC input terminal side of the inverter.
2. From the positive and the negative terminals, remove the
protective covers, hex nut, split lock washer and flat washer.
3. Place the positive ring connector onto the positive inverter
terminal. Place the negative ring connector onto the negative DC
input terminal.
4. Place a flat washer and split lock on top of each ring connector.
Put the positive and negative hex nuts over these and tighten to
create a secure connection and prevent excessive heating at this
connection. Insufficient tightening of the terminals could void your
warranty.
5. Install the positive and negative protective covers.
6. Connect Ground: Using the ground wire, directly connect the
Main Ground Screw to the vehicle's chassis or earth ground.
See Feature Identification to locate the Main Ground Screw.
All installations must comply with national and local codes and
ordinances.
7. Connect Fuse: In addition to the protection provided by the
Inverter's internal fuses, NEC article 551 requires that you connect
the Inverter's positive DC Terminal(s) directly to UL-listed fuse(s)
and fuse block(s) within 18 in. (457 mm) of the battery. Refer to
the diagrams below for proper fuse placement.
FUSE 18 in.
17
(457 mm)
