Idiomas disponibles
Idiomas disponibles
Remaining hazards
The machine has been built using modern technol-
ogy in accordance with recognized safety rules.
Some remaining hazards, however, may still exist.
• Only process selected woods without defects such
as: Branch knots, edge cracks, surface cracks.
Wood with such defects is prone to splintering and
hazardous.
• Wood which is not correctly glued can explode when
being processed due to centrifugal force.
• Trim work piece to a rectangular shape, center and
correctly secure before processing. Unbalanced
work pieces can be hazardous.
• Injuries can occur when feeding work pieces if tool
supports are not correctly adjusted or if turning tools
are blunt. Sharp turning tools which are free of de-
fects are necessary for professional turning.
• Long hair and loose clothing can be hazardous when
the work piece is rotating. Wear personal protective
gear such as a hair net and tight fitting work clothes.
• Saw dust and wood chips can be hazardous. Wear
personal protective gear such as safety goggles and
a dust mask.
• The use of incorrect or damaged mains cables can
lead to injuries caused by electricity.
• Even when all safety measures are taken, some re-
maining hazards which are not yet evident may still
be present.
• Remaining hazards can be minimized by following
the instructions in „Safety Precautions", „Proper
Use" and in the entire operating manual.
• Before carrying out any adjustment or maintenance
work, switch off the device and disconnect the mains
plug.
6. Technical data
AC motor
Power
Operating mode
Spindel speed
Max. workpiece length
Max. workpiece diameter
Headstock thread
Weight
Dimensions L x W x H mm
* Operating mode S1, continuous operation
220 - 240 V~ 50Hz
550 Watt
S1 *
800 - 3000 min
-1
600 mm
25 cm
M 18 x 1,5
6,7 kg
1010x154x215
www.scheppach.com
Noise
Total vibration values determined in accordance with
EN 62841.
Sound pressure level L
pA
Uncertainty K
pA
Sound power level L
WA
Uncertainty K
WA
Wear hearing protection.
The effects of noise can cause a loss of hearing. Total
vibration values (vector sum - three directions) deter-
mined in accordance with EN 62841.
7.
Before putting into operation
• Open the packaging and remove the device care-
fully.
• Remove the packaging material as well as the pack-
aging and transport bracing (if available).
• Check that the delivery is complete.
• Check the device and accessory parts for trans -
port damage.
• If possible, store the packaging until the warranty
period has expired.
m ATTENTION
The device and packaging materials are not toys!
Children must not be allowed to play with plastic
bags, film and small parts! There is a risk of swal-
lowing and suffocation!
• The machine must be securely installed, i.e. bolted
down on a workbench, base frame or similar.
• Before the machine is put into operation, all covers
and safety devices must be properly attached.
• In the case of wood which has already been worked
with, check for foreign bodies such as nails or
screws etc.
• Before connecting the machine, check that the data
on the type plate matches those of the mains sys-
tem.
• The machine must only be connected to a properly
installed safety socket which is protected by a fuse
of at least 16A.
86,6 dB
3 dB
99,6 dB
3 dB
GB | 25
