Idiomas disponibles
Idiomas disponibles
English
CAUTION
1. If liquid leaking from the battery gets into your eyes, do
not rub your eyes and wash them well with fresh clean
water such as tap water and contact a doctor
immediately.
If left untreated, the liquid may cause eye-problems.
2. If liquid leaks onto your skin or clothes, wash well with
clean water such as tap water immediately.
There is a possibility that this can cause skin irritation.
3. If you find rust, foul odor, overheating, discolor,
deformation, and/or other irregularities when using the
battery for the first time, do not use and return it to your
supplier or vendor.
WARNING
If a conductive foreign matter enters in the terminal of
lithium ion battery, the battery may be shorted, causing fire.
When storing the lithium ion battery, obey surely the rules
of following contents.
○ Do not place conductive debris, nail and wires such as
iron wire and copper wire in the storage case.
○ To prevent shorting from occurring, load the battery in
the tool or insert securely the battery cover for storing
until the ventilator is not seen.
REGARDING LITHIUM-ION BATTERY
TRANSPORTATION
When transporting a lithium-ion battery, please observe the
following precautions.
WARNING
Notify the transporting company that a package contains a
lithium-ion battery, inform the company of its power output
and follow the instructions of the transportation company
when arranging transport.
○ Lithium-ion batteries that exceed a power output of
100 Wh are considered to be in the freight classification
of Dangerous Goods and will require special application
procedures.
○ For transportation abroad, you must comply with
international law and the rules and regulations of the
destination country.
Power Output
Wh
2 to 3 digit number
USB DEVICE CONNECTION
PRECAUTIONS (UC18YSL3)
When an unexpected problem occurs, the data in a USB
device connected to this product may be corrupted or lost.
Always make sure to back up any data contained in the
USB device prior to use with this product.
Please be aware that our company accepts absolutely no
responsibility for any data stored in a USB device that is
corrupted or lost, nor for any damage that may occur to a
connected device.
WARNING
○ Prior to use, check the connecting USB cable for any
defect or damage.
Using a defective or damaged USB cable can cause
smoke emission or ignition.
○ When the product is not being used, cover the USB port
with the rubber cover.
Buildup of dust etc. in the USB port can cause smoke
emission or ignition.
NOTE
○ There may be an occasional pause during USB
recharging.
○ When a USB device is not being charged, remove the
USB device from the charger.
Failure to do so may not only reduce the battery life of a
USB device, but may also result in unexpected
accidents.
○ It may not be possible to charge some USB devices,
depending on the type of device.
NAMES OF PARTS
The numbers in the list below correspond to Fig. 1–Fig. 32.
1
Switch
2
Switch lock
3
Dust collection nozzle
4
Cutting depth lever
5
Incline wing nut
6
Lower guard
7
Bolt
8
Washer (B)
9
Saw blade
10
Guide piece
11
Base
12
Incline lever
13
Guide fastener knob bolt
14
Lock lever
15
LED light
16
Battery
17
Hex. bar wrench
18
Handle
19
Sub handle
20
Charge indicator lamp
21
M6 fastening screw (×2)
22
M6 knurled knob
23
Bevel plate (B)
24
Angle adjustment screw
25
Angle adjustment screw (for 45°) (×2)
26
Mode selector switch
27
Silent mode indicator lamp
28
Lighting mode switch
29
Lighting mode indicator lamp
30
Guide
14
