Tabla de contenido
Idiomas disponibles
Idiomas disponibles
AVENTICS | EBS-PT | R412008280–BAL–001–AE | English
English
1
About this document
These instructions contain important information on the safe and
appropriate assembly and operation of the EBS-PT ejector and
how to remedy simple malfunctions yourself.
O
Read these instructions completely, especially chapter "For
your safety" before working with the EBS-PT ejector.
Related documents
The EBS-PT ejector is a single component. Also follow the
instructions for the other system components.
This includes:
W
Manufacturer's system documentation
Additional information on the EBS-PT ejector can be found in the
online catalog (www.aventics.com/pneumatics-catalog).
Abbreviations used
Abbreviation
EBS
EBS-PT
2
For your safety
The EBS-PT has been manufactured according to the accepted
rules of safety and current technology. There is, however, still a
danger of personal injury or damage to equipment if the following
general safety instructions and the warnings before the steps
contained in these instructions are not complied with.
O
Read these instructions completely before working with the
EBS-PT.
O
Keep these instructions in a location where they are accessible
to all users at all times.
O
Always include the operating instructions when you pass the
EBS-PT on to third parties.
Intended use
The EBS-PT is used to convert the energy from the compressed air
into a vacuum.
O
The EBS-PT is only intended for industrial applications.
O
Observe the performance limits listed in the technical data.
Intended use includes having read and understood these
instructions, especially the chapter "For your safety".
Improper use
The EBS-PT may not be used to exhaust liquids, gases, or
granulates.
It is considered improper use when the EBS-PT
W
is used for any application not named in these instructions,
W
is used under operating conditions that deviate from those
described in these instructions.
Meaning
Ejector
Pneumatic T design
Personnel qualifications
Assembly, disassembly, commissioning, and operation require
basic pneumatic knowledge, as well as knowledge of the
appropriate technical terms. Assembly, disassembly,
commissioning, and operation may therefore only be carried out by
qualified pneumatic personnel or an instructed person under the
direction and supervision of qualified personnel.
Qualified personnel are those who can recognize possible hazards
and institute the appropriate safety measures due to their
professional training, knowledge, and experience as well as their
understanding of the relevant conditions pertaining to the work to
be done. Qualified personnel must observe the rules relevant to the
subject area.
Safety instructions in this document
In this document, there are safety instructions preceding the steps
whenever there is a danger of personal injury or damage to the
equipment. The measures described to avoid these hazards must
be observed.
Safety instructions are set out as follows:
SIGNAL WORD
Type/source of danger
Consequences
O
Precautions
Indicates a potentially hazardous situation, which, if not
avoided, could result in minor or moderate injury or damage to
the equipment.
The following must be observed
General safety instructions
W
Observe the regulations for accident prevention and
environmental protection for the country where the device is
used and at the workplace.
W
Do not change or modify the EBS-PT.
W
Only use the EBS-PT within the performance range provided in
the technical data.
W
Do not place any mechanical loads on the EBS-PT under any
circumstances.
W
Always comply with country-specific regulations.
Before assembly
W
Make sure that the relevant system part is not under pressure
before you assemble the EBS-PT.
During assembly
W
Make sure that all the connections on the EBS-PT are properly
connected and all the plastic tubing is firmly fitted.
During operation
Only use compressed air in accordance with ISO 8573-1:2010
(max. particle size: 40 μm; pressure dew point: ≤ 3 °C; oil content:
3
≤ 5 mg/m
) as the medium.
CAUTION
5
Tabla de contenido
