Idiomas disponibles
Idiomas disponibles
English
Owner´s manual
•
pressure, the safety valve opens and lets the compressed air escape, thus reducing the pressure in the
compressor.
ATTENTION: Wear safety glasses. Check the safety valve by following these steps:
DANGER:
If air leaks after releasing the ring, or if the valve is stuck and cannot be actuated by the ring, remove the
compressor from operation. The safety valve must be replaced if it cannot be actuated or if it leaks air after
the ring is released. DO NOT use the air compressor until the safety valve has been replaced. Use of
the air compressor under these conditions can cause death or serious bodily injury.
Thermal overload protector
This compressor has an automatic thermal protector that shuts down the motor if it overheats or has too
much current. This protector is a "trip and hold" protector. To reset it, unplug the compressor and allow
it to cool completely. This should allow the automatic overload to reset. The protector cannot be reset
unless it is unplugged.
The motor must cool down before it can be started. The motor may restart automatically without warning
if the plug is plugged into the outlet and the motor is turned on.
7. CLEANING, MAINTENANCE AND STORAGE
ATTENTION: Clean and maintain your compressor carefully and regularly. This is the only way to
ensure proper operation and a long service life. Regardless of the number of jobs or performances, service
and clean the unit after each use.
As far as possible, inspections, adjustments and maintenance work should be carried out by the same
person or his substitute and documented in a maintenance book.
Be sure to observe the following instructions when carrying out maintenance and cleaning work:
• Switch off the compressor before carrying out any work on it.
• Disconnect the compressor from the mains by unplugging it. This disconnects the compressor from the
mains.
• Release pressure from the compressor to avoid material damage. You can, for example, connect a
compressed air blow gun to the compressor and thus empty the pressure vessel.
• Before each use, check the machine for damage, especially the cable and plug.
1. Turn on the air compressor and allow the reservoir to fill.
The compressor will shut off when the pressure reaches the
preset maximum.
2. Turn off the air compressor.
Pull the safety valve ring to release the air for several seconds.
ALWAYS use your hand to prevent the rapidly moving air
from passing over your face.
4. Release the ring and the air will stop coming out.
27
