Idiomas disponibles
Idiomas disponibles
JN$TAL TI©N
• Connectthe straightcoupling of the inlet hose
to thewater tap and make sureto tighten it.
• Connectthe elbow coupling of the inlet hose
to each inlet valves of the unit and make sure
to tighten it.
Note:
• Pleasebe surethat the COLD inlet hoseis
connectedwith the valve for cold water
(markedwith "C").
• Pleasebe surethat the HOT inlet hoseis
connectedwith the valve for hotwater
(markedwith "H").
Water Inlet Hoses
Note:
A flat rubber washer must be present inside each end of the inlet hoses.
Over tightening may cause damage to the valve.
Water
Drainage
Hose
• Theheight of the pipe for the water drainage
hoseshould be between2'6" to 3'3". The
water drain hosemustbe securelyplaced
oO oE
on the clip on the back of the washing machine. _
o
GO
• Usethe water drainage support (bracket)
suppliedas an accessoryfor proper installation.
If the water drain hoseneedsto be extended,
it should not be extendedmore than 8'2".
(Longerextensionwill result in concurrentwater
inflow and outflow.) The diameter of the extension
hoseshould be the same as the original hose.
Caution: Water drainage hosemust not be immersedin water. Theoriginal and
extensionhosesshouldbe tightly connected.
11
