Idiomas disponibles
Idiomas disponibles
This appliance is intended for household use only.
w WARNING
Electrical Shock Hazard: This appliance is provided
with a polarized plug (one wide blade) to reduce the risk of electric
shock. The plug fits only one way into a polarized outlet. Do not
defeat the safety purpose of the plug by modifying the plug in any
way or by using an adapter. If the plug does not fit fully into the
outlet, reverse the plug. If it still does not fit, have an electrician
replace the outlet.
The length of the power cord used on this appliance was selected
to reduce the hazards of becoming tangled in or tripping over a
Filter capacity: Approximately 120 gallons (454 liters)
Rated service flow: Up to 0.5 gal/min (1.9 L/min)
Wattage: 29 W
Pump pressure range: 15–70 PSI
The replacement filter model number is CT01.
See everything Brita filters out. Scan the QR code or
visit brita.com/performance-data.
Water reservoir is for municipally treated tap water only. Do not
use with water that is microbiologically unsafe or of unknown
quality without adequate disinfection before or after the system.
4
Other Consumer Safety Information
longer cord. If a longer cord is necessary, an approved extension
cord may be used. The electrical rating of the extension cord
must be equal to or greater than the rating of the appliance. A
common 18-gauge household extension cord is rated for 600 watts
and this appliance uses 29 watts. Care must be taken to arrange
the extension cord so that it will not drape over the countertop
or tabletop where it can be pulled on by children or accidentally
tripped over.
To avoid an electrical circuit overload, do not use another
high-wattage appliance on the same circuit with this appliance.
Technical Specifications
Water minimum temperature: 33°F (1°C)
Water maximum temperature: 90°F (32°C)
NOTE: Filter is not to be used with hot water.
Performance Data Sheet
Brita Hub™ Filter (Model #CT01) has been certified
by IAPMO R&T in System Model 87340 against NSF/
ANSI Standard 53 for the reduction of contaminants
specified on the Performance Data Sheet.
The Brita Hub™ Filter (Model #CT01) has been
certified by WQA in System Model 87340 against
NSF/ANSI Standards 42, 53, and 401 for the reduction
of contaminants specified on the Performance Data
Sheet.
