Idiomas disponibles
Idiomas disponibles
How to Dispense Filtered Water
1.
Plug into outlet.
How to Reset FILTER LIFE Light
If water flows too slowly but the indicator is still flashing green
or yellow, you may have poor water quality (e.g. sediment,
sand, rust, etc.) that requires more frequent filter replacement to
maintain the desired flow rate.
If you're replacing your filter at or past its useful life (red light is
on or flashing):
Remove used Filter and replace with new Filter. When new filter is
installed, the indicator will automatically reset and the FILTER LIFE
Light will turn green. It's that easy.
2.
Place your glass or bottle on
Drip Tray.
3.
Press and release 12 oz or 20 oz Button to dispense water,
depending on your glass or bottle size. After selected amount of
water is dispensed, unit will automatically shut off. FILTER LIFE Light
will illuminate, letting you know filter status. Do not remove cup until
FILTER LIFE Light and pump turn off.
NOTE: To cancel a 12 oz or 20 oz cycle, press any button while water
is dispensing. Pump and FILTER LIFE Light will turn off. All dispensed
amounts will reset.
3.
Press and hold ( ) Manual Dispense Button to activate pump to
dispense desired amount of water. FILTER LIFE Light will illuminate,
letting you know filter status. When Button is released, FILTER LIFE
Light will turn off and water flow will stop.
NOTE: Remember to flush new Water Filter according to
directions on page 8.
Replacing Filter before end of life (green or yellow light on
during use):
If you need to replace the Filter before the indicator is flashing
red, the indicator will need to be manually reset. After installing
the new Filter, press and hold both 12 oz and 20 oz Buttons for
3 seconds. This will reset the indicator, and the FILTER LIFE Light
will turn green.
OR
9
