Idiomas disponibles
Idiomas disponibles
How to Change Water Reservoir Location
Determine the Water Reservoir location that best suits your space: Right side or back of Brita
Hub™. Your Brita Hub™ is initially set to the right side configuration. If that's your preferred
configuration, no need to follow the steps below!
For best results, we recommend you select your configuration before first use.
1.
Unplug power cord from
electrical outlet. Slide out Drip
Tray, remove Water Reservoir
Lid and lift Water Reservoir by
Handle to remove from Base. If
changing the configuration after
already using your Brita Hub ™ ,
make sure you've emptied any
remaining water from Water
Reservoir and set it aside.
2.
Lay Brita Hub ™ on left side.
Locate Spacer on back of
Hub and pull towards you to
remove. Gently pull down
on Water Reservoir Base
to remove. Do not attempt
to remove attached Hose.
NOTE: Water might leak onto
countertop if Hub has been
used.
3.
While keeping the power cord
out of the way, align opening
on back of Hub with Water
Reservoir Base. Push up to
snap Water Reservoir Base
into place. Thread power cord
through power cord holder
on bottom of Water Reservoir
Base.
4.
Push Spacer into opening
on right side of Hub. Move
Hub upright onto countertop.
Hold Water Reservoir flat side
towards Hub, and place onto
Water Reservoir Base, aligning
opening on Water Reservoir
bottom with opening on Water
Reservoir Base. Slide Drip Tray
into place.
7
