Idiomas disponibles
Idiomas disponibles
3.9 Partition for Paper Roll
Set the partition to the width of the paper roll you are loading.
1.
Turn off the power.
2.
Pull the cover open lever forward and open the paper cover.
3.
Set the partition in a slot that matches the size of the paper roll you are using.
When using 83-mm wide roll paper, the partition must be removed.
When using 80-mm wide roll paper, the partition must be installed in the 80-mm position.
When using 60-mm wide roll paper, the partition must be installed in the 60-mm position.
When using 58-mm wide roll paper, 2 partitions must be installed in the 58-mm and 60-mm
positions.
4.
Refer to "5.3 Manual Setting of Memory Switches" to change the paper width settings.
CAUTION
Make sure the partition is not slanted when setting it for 58-mm or 60-mm paper rolls.
When a partition is installed in the 58-mm groove, install a partition in the 60-mm groove also.
Installing 2 partitions prevents the partitions from skewing.
When using 58-mm wide paper, use the printer as a dedicated printer for that paper size.
The printer may not correctly feed paper or print if it is switched to 80-mm wide paper after
using 58-mm wide paper.
Partition
*1
*1
*2
Notes:
*1: 2-inch (58/60 mm) paper
*2: 3-inch (80/83 mm) paper
— 36 —
