Connecting the wireless LAN adapter
1.
Turn off the power.
2.
Connect the wireless LAN adapter to the connector.
Panel button operation
Board operations are performed using the panel button on the rear of the LAN board.
Panel button
Ethernet
Enabling LAN connection
Turn on the printer. Operation of this board will start about 20 seconds later.
Printing LAN setup information
Press the panel button.
Entering setting mode
Hold down the panel button. A buzzer* will sound once to indicate that setting
mode has been entered.
• You can use setting mode to read factory settings.
• If no operation is performed for 3 seconds in configuation mode, the mode switches back
to normal mode.
Returning to factory settings
Enter the board setting mode, and then hold down the panel button. This returns
the board to its factory settings.
CAUTION
The board will automatically restart after this operation is complete. After clearing settings,
you will need to re-configure netork settings.
Panel button
Wireless LAN
— 29 —
SW
10/100BASE
Panel button
Ethernet/Wireless LAN
USB host model