Idiomas disponibles
Idiomas disponibles
ENGLISH
Mixed tank. Fig. 14:
-
Remove the mixed tank.
Open the mixed tank cover and empty it.
-
-
Remove the filter and filter holder as shown in figure 14.
Use the self-cleaning brush to clean the inside of the mixed tank.
-
You can clean the dust compartment with water, without immersing the tank. Male sure
-
the tank is completely dry before re-installation to prevent water to reach the motor and
damage the robot vacuum cleaner.
Reinstall the mixed tank on the robot vacuum cleaner.
-
High-efficiency filter. Fig. 15:
The high-efficiency filter is designed with fibres that help trap dust particles, dust mites,
-
pollen... It is very important to periodically clean the filter, to prevent these particles
from building up in the filter, causing efficiency loss. It is convenient to carry out this
maintenance once a week.
-
Replace the high-efficiency filter every 3 months, depending on the frequency and type of
use.
Recommendation
You can remove dirt from the high-efficiency filter with a small brush or gently shake the filter
on a hard surface to remove the dust. The high-efficiency filter cannot be washed.
Primary mesh filter and sponge filter
The filtering system is featured with a primary mesh filter and a sponge filter, located next to
the high-efficiency filter. It is suggested to replace them either after a maximum of 160 hours
of use or when they are worn out due to operation.
Recommendation
Dirt can be removed with a small brush or by shaking carefully against a hard surface for dust
to fall off. You can also use warm water without detergents to obtain better results. Always
make sure they are completely dry before installing them again; otherwise, moisture can reach
the robot vacuum cleaner's motor and damage it.
Cleaning the fall-detection sensors
Use a clean, dry, and soft cloth to wipe off any dust from the fall-detection sensors located on
the robot vacuum cleaner's lower part.
Sensors. Fig 16:
-
The robot vacuum cleaner has different types of sensors, for example, proximity sensors
that allow the robot to move around while detecting obstacles or fall-detection sensors
that help the robot detect slopes or possible gaps/unevenness such as staircases. These
60
CONGA 7490 IMMORTAL HOME X-TREME
