How To Reset Your Unit; How To Forcibly Eject A Disc - JVC KW-NX7000 Manual De Instrucciones

WARNINGS:
To prevent accidents and damage
• DO NOT install any unit or wire any cable in a
location where;
– it may obstruct the steering wheel and
gearshift lever operations.
– it may obstruct the operation of safety devices
such as air bags.
– it may obstruct visibility.
• DO NOT operate the unit while driving.
If you need to operate the unit while driving, be
sure to look around carefully.
• The driver must not watch the monitor while
driving.
• If the parking brake is not engaged, "Parking
Brake" flashes on the monitor, and no playback
picture will be shown.
– This warning appears only when the parking
brake wire is connected to the parking
brake system built in the car (refer to the
Installation/Connection Manual).
[European Union only]
Notes on the SD slot for System
updating:
The SD slot marked below is for System updating. To
update the System, ☞ page 18.
• Do not remove the cover in any case other than
updating the System.
SD slot for system updating
For safety...
• Do not raise the volume level too much, as this will
block outside sounds, making driving dangerous.
• Stop the car before performing any complicated
operations.
Temperature inside the car...
If you have parked the car for a long time in hot or cold
weather, wait until the temperature in the car becomes
normal before operating the unit.
Every time you turn on the unit or attach the monitor
panel with the ignition switch turned on, the screen
below appears. Pay sufficient attention when operating
the unit and make sure of safe driving.

How to reset your unit

• Your preset adjustments will also
be erased.

How to forcibly eject a disc

Press and hold OPEN/TILT while holding
[Hold]
• If this does not work, reset the unit.
3
/ATT.
[Hold]
INTRODUCTION