Idiomas disponibles
Idiomas disponibles
PROTECTION AGAINST OVERHEATING
− An additional fitted safety thermostat protects the heater against overheating and swit-
ches it off automatically. The service lamp then goes out.
− If the device switches itself off, disconnect the mains plug from the socket. The heater is
ready for service again after a short cooling-off phase (approx.15 minutes). Plug the mains
plug back into the socket.
− If this repeats itself, first check whether the thermostat switch is set correctly or if ob-
jects hinder the heating operation.
CLEANING THE HEATER
Always un-plug the heater from the wall socket and allow it to cool down before
cleaning.
Clean the outside of the heater by wiping with a damp cloth and buff with a dry cloth.
Do not use any detergents or abrasives and do not allow any water to enter the heater.
STORING THE HEATER
When the heater is not used for long periods of time, it should be protected from dust and
stored in a clean dry place.
Note: this appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless they
have been given supervision or instruction concerning use of the appliance by a person
responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
Information requirements for electric local space heaters
Model identifier(s): Polux Nano
Item
Heat output
Nominal heat
output
Minimum heat
output (indica-
tive)
Maximum
continuous heat
output
Symbol
Value Unit
P nom
1,80
KW
P min
0,75
KW
P máx,c
1,80
KW
Item
Type of heat input, for electric storage
local space heaters only (select one)
manual heat charge control,
with integrated thermostat
manual heat charge control with
room and/or outdoor tempera-
ture feedback
electronic heat charge control
with room and/or outdoor tem-
perature feedback
Unit
Not
appli-
cable
Not
appli-
cable
Not
appli-
cable
21
