Cleaning
the Shuttle Race
This area must be kept free of dust, lint and
occasional tangled thread. Clean the shuttle race area
about every three months.
• Cleaning
the shuttle
area
_t_ Bobbin case
Levers
Shuttle race cover
Shuttle
Shuttle race
Center pin on the shuttle
Raise the needle bar to its highest point and remove the
bobbin case_.
Push shuttle race levers (_ aside. Lift shuttle race
cover (_ and take shuttle (_ out.
Clean the shuttle race @ with a lint brush.
Put a drop of oil on the center pin of the shuttle (_ and
shuttle race@.
Do not over oil.
S
tLJ
J
• Replacing
shuttle
assembly
Levers
(_ Shuttle race cover
(_ Shuttle
(_ Shuttle race
Center pin on the shuttle
(_ Shuttle driver
Pointed hook
(Oil here)
Turn handwheel so that shuttle driver (_ is forming half
moon on the left side of the machine.
Hold shuttle(_
by center pin _) and position shuttle so as
to form a half moon on the right side. The pointed hook
will be on the bottom.
Place shuttle race cover (_ into place over shuttle
assembly.
Snap the levers (_ back into the original position.
@
\\
I
J
7O
