Idiomas disponibles
Idiomas disponibles
5.5.3. Batteries: removal
When removing the batteries, the operator must be equipped with suitable personal
protection devices (gloves, goggles, overalls, safety shoes, etc) to reduce the risk
of accidents. Make sure the switches on the control panel are in the "0" position
(off) and the machine is turned off. Keep away from naked flames, do not short
circuit the battery poles, do not cause sparks and do not smoke. Proceed as
• disconnect the battery wiring and bridge terminals from the battery poles.
• if necessary, remove the devices fixing the battery to the base of the machine.
• lift the batteries from the compartment using suitable lifting equipment.
5.6.
Battery charger (battery models)
Never allow the batteries to become excessively flat as this could damage them
5.6.1. Choosing the battery charger
Make sure the battery charger is compatible with the batteries to be charged:
− tubular lead batteries: a 24V - 20 A automatic charger is recommended. Consult the
battery charger manufacturer and manual to confirm the choice.
− gel batteries: use a charger specific for this type of battery.
Use CE-marked battery chargers that comply with the relevant product standards
(EN60335-2-29), featuring double or reinforced insulation between input and output,
5.6.2. Preparing the battery charger
If you wish to use a battery charger not provided with the machine, you must fit it with the
connector supplied with the machine (see paragraph "Unpacking" of this manual).
The connector supplied for the external battery charger is suitable for cables with a
minimum cross-section of 4 mm2
To install the connector, proceed as follows:
•
remove about 13 mm of protective sheath from the red and black wires of the battery
charger;
•
insert the wires into the connector contacts and squeeze them forcefully with suitable
pliers;
•
respect the polarity (red wire + black wire –) when inserting the wires into the
connector.
ENGLISH
12
! DANGER
follows:
IMPORTANT
irreparably.
! DANGER
and a SELV output circuit
