Idiomas disponibles
Idiomas disponibles
•
Respect the minimum distances given in figure 2 below.
2
20 in
50 cm
20 in
20 in
50 cm
50 cm
Proceed as follows:
•
Drill a hole ø 5,25 inches (134 mm) in an outside wall or
through a wooden kickboard. Respect the dimensions and
height of the hole given in figure 2 and 3.
3
in the wooden
kickboard of a French
window or panel
•
Fit the wall flange B1 into the hole.
Fit the assembled hose B3-B4-B5 into the wall flange B1.
•
When the air hose B4 is not connected, the drilled hole can
•
be closed with the flange cap B1.
•
When installing the air conditioner, you should leave a door
slightly open little as 1/2"(1 cm) to guarantee correct ven-
tilation and room pressure.
•
Keep the air hoses as short and free of curves as possible to
avoid constrictions.
Note:
As special tools are required for this type of installation,
we suggest you have the appliance installed by special-
ized personnel.
20 in
50 cm
20 in
50 cm
32 in
80 cm
in the wall:
you are
recommended to insulate the
section of wall using
suitable insulation
AIR CONDITIONING WITH WINDOW INSTALLATION
You can also set up in a double-hung window:
•
Place the window bracket in the window sill, extend the
bracket fully within the window frame, fix the bracket in
place using the locking pin. Attach the provided foam strip-
ping B12 to the top of the window bracket and then lower
the window onto the bracket. (Should the window bracket
be too large for the window, the plastic can be cut with a
saw by a qualified professional.)
•
Fit the air exhaust hose B4 in the relevant housing located
on the rear side of the appliance using hose adapter B5.
Align the open lock symbol on the adapter B5 with the ar-
row on the back of the unit. Turn adapter counter clockwise
until the closed lock symbol is aligned with the arrow, as
shown in figure 1b.
Connect the window outlet vent B2 to the other end of the
•
exhaust hose using hose adapter B3.
Insert the window outlet vent B2 of the exhaust hose into
•
the slot of the window bracket (fig. 4).
4
Other set-up methods:
•
Thanks to the locking pins, it's possible to use the window
bracket also for sliding windows. Position the hole of the
bracket so to allow a correct installation of the exhaust hose
(see fig. 5).
7
