Before Installing - StetSom STM 0803 Manual De Usuario

Introduction
The STM 0803 sound mixer was developed to provide high
performance and sound fidelity with very low noise levels and
harmonic distortion. It is ideal for anyone who wants precise
settings to produce professional sound.
Resources
The STM 0803 has 3 input channels with 8 connections for
Microphone (XLR) and Line (P10 and RCA), as well as rotary
controls that control each channel independently. The controls
are:
• Gain control (GAIN) to adjust the input signal level and 4
controls for equalization of ±15dB (HIGH, MID HIGH, MID LOW
AND LOW);
• Button (MUTE) that turns the channel on/off end the volume
(LEVEL) varies in intensity from 0 to 100%;
• Signal indicator lights (SIGNAL) that are green and also signal
saturation (CLIP) and MUTE indicators that are red.
• It has 1 main output channel (MAIN) that receives and mixes
the signal from all the channels, the MAIN has 1 P10 connections
and 2 RCA connections, a 60mm sliding volume control (MAIN
LEVEL) and a VU Meter with 12 LEDs that show the audio signal
level.
The STM 0803 also has an auxiliary output channel (AUX) that
receives the signal from the MAIN and releases it through
one P10 connections and two RCA connections with rotating
potentiometers for volume (LEVEL) and phase adjustment
(PHASE).
12

Before Installing

Read this manual carefully before installing the console. You
must follow the instructions for the product's installation and
connections to guarantee optimal performance. If necessary, get
in touch with our company.
Before use, pay attention to the following information:
• Make sure the appliance is switched off before adding or
removing any connections. This prevents possible damage to
appliances connected to the console;
• Keep all cables as far away as possible from the ignition cables,
electronic injection modules and starter switch since they may
cause noise interference;
• Always use good quality cables and connectors. This guarantees
quality and sound fidelity;
• To avoid damaging the cables, make sure that they do not
touch sharp metal edges.
Important: Use a 1A fuse 30 centimeters from the battery as the
best precaution.
Installation
For installation, choose a
place with easy access to
the product. The fixing,
when necessary, should
be done through the holes
that are protected by plastic
finishes. Remove the latches
and fasten with screws.
Plastic Parts
13