Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Exemple of Installation
Mic
Amplifier
Compatible Cables
2
(HOT)
1
(GND)
3
Balanced Male
(COLD)
Connector XLR (Cannon)
Tip (T)
T (2)
S (1,3)
Ground (S)
Male Connector P10
18
Player 1
Player 2
Amplifier
2
(HOT)
1
(GND)
3
Balanced Female
(COLD)
Connector XLR
2 (T)
1(S)
3 (S)
Female Connector XLR
Troubleshooting
DOES NOT TURN ON OR BLUE LED DOESN'T LIGHT UP:
• The power cables are not connected correctly (terminals +12V,
GND and REM);
• The power cables have a poor connection. Check the
connections;
• REM without signal. Check to see if the REM connection is
receiving about +12V of current;
• Poor ground connection, Check the connections.
NO AUDIO SIGNAL:
• Channel and or Main level control is at the lowest setting.
Increase the setting;
• Channel MUTE button pressed. Release the button by pressing
it again;
• The signal cables from the channels or Main are disconnected.
Check the connections.
DISTORTED AUDIO SIGNAL:
• Distorted/saturated audio signal. Adjust the volume level of the
signal source. Decrease the gain control of the STM 0803 input
channels.
UNWANTED NOISE:
• All RCA and power cables should be checked beforehand for
irregularities and corrected if necessary;
• Use cables that suppress interference on the spark plugs;
• Route the incoming and outgoing RCA cables away from any
other cables since they are more sensitive to interference;
• Install a separate power source (+12V) for the sound system;
• Ground the console properly. Remove paint from the chassis
at the selected point, and connect the wire using a grounded
terminal. In order to prevent rust, insulate it with paint;
19
Tabla de contenido
