Idiomas disponibles
Idiomas disponibles
CRAFTSMAN
FULL WARRANTY
If this Craftsman product fails due to a defect in material or workmanship
within two years from the date of purchase, return it to any Sears store, Parts and
Repair Service Center, or other Craftsman outlet in the United States for free repair (or replacement
if repair proves impossible).
This warranty applies for only 90 days if this product is ever used for commercial
or rental purposes.
This warranty
covers
ONLY defects
in material
and workmanship.
Sears will NOT pay for:
•
Expendable items that can wear out from normal use within the warranty period, such as cutting line, air cleaner or spark plug.
Repairs necessary because of accident or failure to operate or maintain the product according
to all supplied instructions.
Preventive maintenance,
or repairs necessary due to improper fuel mixture, contaminated
or stale fuel.
This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.
Sears, Roebuck and Co., Hoffman Estates, IL 60179
APPLICATIONS
As a trimmer:
Cutting grass and light weeds.
Edging
Decorative trimming around trees, fences, etc.
Starter
Rope
Grip
Muffler
\
Spark
Plug
D-Handle
On/Off Control
Shaft Grip
Oil Fill Plug
Fuel Cap
Choke
Lever
Attachment
Shaft
Throttle
Control
Cutting
Head Shield
\
Convertible
TM
Coupler
Air Filter
Cover
Primer
Bulb
Line Cutting
Blade
Hassle
Free ® PLUS
Cutting
Head
ADJUSTING
THE D-HANDLE
1.
Loosen the screws on the D-
handle (Fig. 1).
2.
While holding the unit in the
operating position (Fig. 13),
position the D-handle to the
location that provides the
best grip.
3.
Tighten the clamp screws
evenly, until the D-handle is
secure.
iNSTALL CUTTING
ATTACHMENT
SHIELD
,
Shaft Grip
Min. 6 in.
(15.24 cm)
Screw
Fig. I
D-Handle
m
]
_
WARNING:
To prevent serious personal injury, never operate
the unit without the cutting attachment
shield in place.
Use the following
instructions
if
\
the cutting attachment
shield on
the unit is not installed.
Cutting
t/
Head Shield
1.
Place the cutting head shield
onto the guard mount
Guard
bracket, making sure to align
Mount
the holes on the shield with
Bracket
the ones in the guard mount
bracket. (Fig. 2)
2.
Take the 2 shield screws and
screw each one into the
shield until finger tight.
Fig. 2
3.
Using an appropriate
screw
driver, tighten the screws until the shield is firmly in place. Make sure
the screws are tightened equally so there is a balanced gap between
the bracket and the shield on each side.
