Idiomas disponibles
Idiomas disponibles
MAiNTAiNiNG
THE
PNEUMATIC
TOOL
[_WARNING:]
When working
on air tools, note the warnings
in this manual and use extra care evaluating
problem tools.
REPLACEMENT
PARTS:
BOSTITCH
replacement
parts are recommended.
Do not use modified
parts or parts which will not give
equivalent
performance
to the original equipment,
ASSEMBLY
PROCEDURE
FOR SEALS:
When
repairing
a tool, make sure the internal
parts are clean and lubricated.
Use Parker "O"-LUBE
or
equivalent
on all "O"-rings.
Coat each "O"-ring with "O"-LUBE
before assembling.
Use a small amount of oil
on all moving surfaces and pivots,
After reassembly
add a few drops of BOSTITCH
Air Tool Lubricant
through
the air line fitting before testing,
AiR SUPPLY-PRESSURE
AND VOLUME:
Air volume is as important as air pressure, The air volume supplied to the tool may be inadequate
because
of
undersize fittings and hoses, or from the effects of dirt and water in the system. Restricted air flow will prevent
the tool from receiving an adequate
volume of air, even though the pressure
reading is high, The results will
be slow operation,
misfeeds or reduced
driving power. Before evaluating
tool problems
for these symptoms,
trace the air supply from the tool to the supply source for restrictive
connectors,
swivel fittings, low points
containing water and anything else that would prevent full volume flow of air to the tool,
-9-
