Idiomas disponibles
Idiomas disponibles
AIR
SUPPLY
AND
CONNECTIONS
L_WARNING: J Do not use oxygen, combustible
gases, or bottled gases as a power source for this tool as
tool may explode,
possibly
causing
injury.
FITTINGS:
Install a male plug on the tool which is free flowing
and which will release
air pressure from the too! when
disconnected
from the supply source.
HOSES:
Air hoses shoutd have a minimum of 150 p.s.i. (10.6 kg/cm2) working
pressure
rating or 150 percent of the
maximum pressure that coutd be produced in the air system.
The supply hose should contain a fitting that will
provide "quick disconnecting"
from the male plug on the tool.
SUPPLY SOURCE:
Use only clean regulated compressed air as a power source for this toot. NEVER USE OXYGEN, COMBUSTIBLE
GASES, OR BOTTLED GASES, AS A POWER SOURCE FOR THIS TOOL AS TOOL MAY EXPLODE.
REGULATOR:
A pressure
regulator
with an operating
pressure
of 0 - 125 p.s.i. (0 - 8.79 kg/cm 2) is required to control the
operatiing pressure for safe operation of this tool. Do not connect this tool to air pressure which can potentially
exceed 200 p.s.i. (14 kg/cm 2) as tool may fracture or burst, possibly causing
injury.
OPERATING
PRESSURE:
Do not exceed
recommended
maximum
operating
pressure
as tool wear will be greatly increased.
The air
supply must be capable of maintaining
the operating pressure at the tool. Pressure drops in the air supply can
reduce the tool's driving power. Refer to "TOOL SPECIFICATIONS"
for setting the correct operating pressure
for the too!.
FILTER:
Dirt and water in the air supply are major causes of wear in pneumatic
tools. A filter will help to get the best
performance
and minimum
wear from the too!. The filter must have adequate
flow capacity for the specific
installation. The fitter has to be kept clean to be effective in providing ctean compressed
air to the tool. Consult
the manufacturer's
instructions
on proper maintenance
of your filter. A dirty and clogged filter will cause a
pressure drop which will reduce the tool's performance.
LUBRICATION
Frequent,
but not excessive,
lubrication
is required
for best performance.
Oil added
through
the air line
connection will lubricate the internal parts. Use BOSTITCH
Air Tool Lubricant, Mobil Velocite #10, or equivalent.
Do not use detergent
oil or additives as these lubricants wilt cause accelerated
wear to the seals and bumpers
in the tool, resulting in poor tool performance
and frequent tool maintenance.
if no airline lubricator
is used, add oil during use into the air fitting on the tool once or twice a day. Only a few
drops of oil at a time is necessary. Too much oil will only collect inside the tool and will be noticeable
in the
exhaust cycle.
COLD WEATHER OPERATION:
For cold weather
operation,
near and below freezing,
the moisture in the air line may freeze and prevent tool
operation.
We recommend
the use of BOSTITCH
WINTER
FORMULA
air tool lubricant
or permanent
antifreeze
(ethylene
glycol) as a cold weather
lubricant.
CAUTION:
Do not store tools
in a cold weather
environment
to prevent
frost
or ice formation
on the
tools
operating
valves and mechanisms
that could
cause tool failure.
NOTE:Some
commercial
air line drying
liquids are harmful
to "O'-rings
and seals - do not use these
low temperature
air dryers
without
checking
compatibility,
-5-
