Idiomas disponibles
Idiomas disponibles
.
Insert a flat head screwdriver into the slot at the
lower end of the vacuum door. Make contact with
the vacuum door locking clip and push inward and
upwards (Fig. 4). Then pull the vacuum door and
hold it open.
Locking
Clip
Vacuum
Door Slot
Fig. 4
.
.
While holding the vacuum door open, locate the
assembled vacuum tube (put together in Step 2).
Arrange the tube so the flat area faces the vacuum
door. The grooves on the side of the tube will line up
with the small tabs in the impeller intake (Fig. 5).
From the exterior, align the small arrow on the
vacuum tube with the arrow on the impeller intake.
Push the vacuum tube in firmly and grip it with both
hands. Turn the tube clockwise as far as possible
until it snaps into the detente and locks. When
properly assembled, the dot on the vacuum tube will
align with the dot on the impeller intake.
Vacuum Tube
Groove
_
Flat
Area
Tabs
Impeller Intake
\
Fig. 5
Installing
the Vacuum
Bag
7.
Install the vacuum bag tube over the blower outlet
and push it on until both tabs snap into place (Fig. 6).
Position the bag so its interior elbow slants
downward.
8.
Attach the vacuum bag to the vacuum bag hook
located at the underside of the unit.
J
Elbow
Tabs
\
Vacuum Bag Hook
Fig. 6
Removing the Vacuum Bag
1.
Unhook the bag.
.
.
Remove the vacuum bag by pressing both tabs on
the vacuum bag elbow at the same time and pulling
the bag off the blower (Fig. 6).
Install the blower tube in order to assemble the unit
as a blower.
4.
Make sure the vacuum door is securely latched shut.
WARN ING: Never
operate
the
unit in the blower
configuration
without the vacuum door
secured and latched shut.
