Idiomas disponibles
Idiomas disponibles
ENGLISH
Place the sealing tape supplied with the induction hob to seal it on the hob. Fig. 3
·Do not use silicone. Apply the tape to the edge of the bottom of the induction hob, leaving
about 3 mm from the edge of the glass. Apply the tape all around the perimeter.
·Cut off the excess and join the two ends of the tape to match.
Warning: the worktop material should be impregnated wood or other insulating material. FIG.
4
Type
Length (mm)
AI320
590
In any case, make sure the induction hob is well ventilated and the air inlet and outlet
are not blocked. Make sure the induction hob works correctly.
Note: the safety distance between the hob and a cabinet over the hob must be at least 760
mm.
FIG. 5
A (mm)
Amplitude (mm)
760
Min. 50
Before installing the induction hob, make sure that:
-
The worktop is level and square-shaped, and no structural elements violate the space
requirements.
-
The worktop material is heat resistant.
-
If you install the induction hob over an oven, the latter must have a cooling fan.
-
The installation will comply with all the safety requirements, and the applicable rules and
regulations.
The hob incorporates a safety switch that allows it to be completely disconnected from
-
the mains, which has been installed and positioned in accordance with local electrical
rules and regulations.
The isolating switch must be of an approved model and provide 3 mm contact separation
-
on all poles (or on all active [phase] conductors if local wiring regulations allow this
variation of requirements).
-
The user can easily access the isolation switch with the induction hob installed.
-
If in doubt about the installation, seek advice from local building authorities and
regulations.
-
Use heat-resistant and easy-to-clean finishes (such as ceramic tiles) on the walls
surrounding the induction hob.
68
BOLERO SQUAD I 3200
Height
Width (mm)
(mm)
520
60
C (mm)
Min. 20
Depth
A (mm)
(mm)
56
560
D
Air inlet
Amplitude
X (mm)
(mm)
490
50
E
Air outlet 5 mm
