Reer PI M30 NF K Manual De Instrucciones Original página 32

9.2.1 Delayed switching of the LED
Undamping > 2 s:
0
1: close zone
2: enable zone
9.2.2 Switching of the LED without delay
Undamping < 2 s:
0
1: close zone
2: enable zone
except for the first start-up
*)
12
30 mm
> 3 s
Signal
Power
30
mm
*)
≈ 0 s
Signal
Power
If the target was away from the
sensor for more than approx� 2 s
(> 30 mm), the yellow LED goes on
with a delay of approx� 3 s in case of
damping in the enable zone�
This is also the case if the target is in
the enable zone when the voltage is
switched on�
If the target was away from the sen-
sor for less than 2 s (> 30 mm), the
yellow LED comes on without delay
in case of damping in the enable
zone�