Epson TM-J7000 Manual Del Usuario página 19

3. Insert the cleaning sheet like a standard check.
CAUTION:
Be sure that the sheet is inserted with the correct side up and that it is
inserted in the correct direction.
Use a cleaning sheet only one time; then discard it.
Notes on using the MICR reader
Do not install the printer near any magnetic fields. Be especially careful where you
install your display device and be sure to check the recognition rate of the MICR
reader with the display device in place.
Make sure that the printer is not subjected to any impact or vibration when it is
performing a MICR reading.
Attaching the Fixing Plate for AC Adapter
(only for the TM-J7500/J7600)
Refer to illustration M as you follow these steps. The bold numbers refer to the
numbers in the illustration.
1. Loop the middle of the power cord as shown in the illustration.
(The measurements are only approximate; use them as a guide.)
2. Put the looped part of the power cord inside the printer in the location
indicated by the circle.
3. Arrange the power cord beside the two projections (13) on the bottom of the
printer to hold it in place; then place the power supply into the printer with
the label side face up.
4. Attach the fixing plate (15) and tighten the screws (14).
Notes:
When integrating the AC adapter in the printer, be sure to carry out the following.
• Be sure to use AC adapter PS-180 (Model name: M159A).
• Use a straight plug for the AC inlet side of the power cable, if possible. If you do use
an L-shaped plug, install the printer near the power outlet and be sure that the plug
can be easily disconnected.
• Be sure to read the information on the label of the AC adapter (rating, Warning/
Cautions) thoroughly and understand it well before you integrate the AC adapter into
the printer unit.
TM-J7000/J7100 – TM-J7500/J7600 User's Manual 11
English