Idiomas disponibles
Idiomas disponibles
REFILLING WATER DURING OPERATION
• Turn paver switch off and unplug the power cord.
•
Press down
steam tdgger (4.8,A) to release
pressure. When
tank is under
pressure, the
safety
pressure
indicator
will
rise above
the
surface of the cap (4.9,B). When the tank is not
under pressure the safety pressure indicator wi!l
be flush or below the su#ace (4.9,C).
= Wait 7-t0
minutes
until the safety
pressure
indicator has gone down, which
indicates the
steamer
has cooled, After
10 minutes,
if the
safety pressure indicator has net fully dropped,
release
residual
steam
pressure by pressing
trigger
and
then
gently
pushing
the
safety
pressure indicator. Slowly unscrew the water fill
safety
cap
counter-clockwise,
but
do
not
remove. Allow machine to ¢0ol an additional
5
minutes.
After you have ensured
the steamer
has cooled
and pressure
has been released,
the water fill safety cap should turn freely for
removal.
Unscrew
the water
fill safety
cap
completely
(4.10).
•
Remove any remaining water to avoid overfilling,
insert funnel and add 1.1L (37oz) o_ clean water
(fill measuring cup to 550m1 (t8.50z) twice) and
pour the water into the tank (4.10). (Max, capacity
of the tank is 1.1L (37oz). Do not overfill the tank,
allow space to be left at the top).
•
Re-install the water f_li safety cap in a clockwise
direction and tighten until completely
sealed.
ACCESS TO BUILT-IN ACCESSORIES
II The
steamer is fitted with
a series of built
in accessories
in the
accessory
holder
compartments
on both sides of the main body_
II 4,1I To access these, press lightly on tabs (D)
on the top of side doors and swing doors down.
