Stiga PARK COMFORT Instrucciones De Uso página 64

EN
Prevent the machine from rolling by al-
ways applying the parking brake.
Stop the engine.
Prevent unintentional starting of the
engine by disconnecting the spark plug
cable(s) from the spark plug(s) and re-
moving the ignition key.
5.3 Tyre pressure
Adjust the air pressure in the tyres as follows:
Front: 0.6 bar (9 psi).
Rear: 0.4 bar (6 psi).
5.4 Changing engine oil
This section contains tables covering the different
engines that are included in STIGA's range. To fa-
cilitate reading, mark the data that applies to the
relevant machine/engine.
5.4.1 Change intervals
The table below states hours of operation and cal-
endar months. Carry out the relevant action at
whichever occurs first.
1st time
Machine
Comfort, Residence Hours of operation/Cal-
(B&S)
Changing the oil
5 hours
Prestige (Kohler) Hours of operation/Cal-
Changing the oil
Ranger (Honda) Hours of operation/Cal-
Changing the oil 20 hours/
1 month
Change the oil more frequently if the engine has to
operate in demanding conditions or if the ambient
temperature is high.
5.4.2 Engine Oil
Use oil according to the table below.
Oil SAE 10W-30
Service class SJ or higher
Use oil without any additives.
Do not fill with too much oil. This can cause the
engine to overheat.
Change oil when the engine is warm.
64
ENGLISH
1. Attach the clamp on the oil drainage hose. Use
2. Move the clamp up 3-4 cm on the oil drainage
3. Collect the oil in a collection vessel.
4. Hand in the oil for disposal in accordance with
5. Install the oil drainage plug and move the clamp
6. Remove the dipstick and fill with new oil.
7. After filling up the oil, start the engine and idle
8. Check to see if there is any oil leakage.
9. Stop the engine. Wait for 30 seconds and then
Then at
5.5 Fuel filter (15, 16, 17:Z)
intervals of
Comfort, Residence, Ranger
endar months Replace the fuel filter every season.
Prestige
50 hours/
12 months
Replace the fuel filter after 1,500 hours of opera-
tion.
endar months Check for fuel leaks once the new filter has been
installed.
- 100 hours
5.6 Transmission, oil (Prestige,
endar months
100 hours/
The oil in the hydraulic power transmission must
6 months
be checked/adjusted and changed at the intervals
given in the table below.
Checking – adjusting level.
Changing the oil.
Type of oil: Synthetic oil 5W-50.
Oil quantity when changing: approximately 3.5 li-
tres.
5.6.1 Check – adjustment
1. Place the machine on a flat surface.
2. Read off the oil level in the reservoir. See fig.
3. If necessary, top up with more oil.
The engine oil may be very hot if it is
drained off directly after the engine is
shut off. Therefore allow the engine to
cool a few minutes before draining the
oil.
a polygrip or similar. See fig. 15-17:Y.
hose and pull out the plug.
NOTE! Do not spill any oil on the drive belts.
local provisions.
back so that it clamps above the plug.
Oil quantity:
Comfort, Residence: 1,6 l
Prestige: 1,9 l
Ranger: 0,9 l
for 30 seconds.
check the oil level in accordance with 4.2.
Residence)
1st time Then at
Action
18. The level should be level with the line.
intervals
of
Hours of operation
- 50
5 200