Cuda surgical Elite 1000 Manual De Usuario página 12

8.2 LIMITED WARRANTY
Your illumination product(s) carry(s) a 3-year warranty from the date of shipment on workmanship
and all defects of material, excluding, fiberoptic cable and lamps. Should your product prove to have
such defects within three years of the shipment, ST Technologies
or component part without charge. Should your illumination product(s) need servicing under this
warranty, please contact ST Technologies
pack the unit in a sturdy carton and ship it to the factory. Include a note describing the defects, your
name, telephone number and a return address. Warranty does not cover equipment subject to
misuse, accidental damage, normal wear and tear or if transferred to a new owner without
authorization from ST Technologies
also have other rights that vary from state to state.
POST WARRANTY REPAIRS: You may return your product(s) for repair, shipping prepaid to the
factory. Your product will be inspected and an estimate of repair charges will be submitted to you for
approval.

In the US call:

FAX number:
9. END OF PRODUCT LIFE
In accordance with the European Waste from Electrical and Electronic Equipment (WEEE) directive,
we encourage our customers to recycle this product whenever possible. Disposal of this unit must be
performed in accordance with the applicable local environmental regulations.
In the US a list of recyclers in your area can be found at: http:/www.eiae.org/.
Please contact customer service to issue a return authorization to return product to manufacturer at
the end of product life.
10. TROUBLESHOOTING
Problem
The power indicator (refer to
4.1) is not lit.
The power indicator is lit, but
Xenon lamp will not ignite.
®
LIT-217 CUDA Surgical
Rev. D
®
for return authorization documentation. Please carefully
®
. This warranty gives you specific legal rights and you may
877 814-2237
904 733-4832
Solution
A. Check that the AC power cord is properly connected.
B. Check the circuit breakers. If necessary, reset.
C. Power input switch is in the off position
A. Check to make sure lamp cartridge is seated properly.
B. Check that the lamp door is secured.
C. Check hour meter; if lamp hours exceed the rated
lamp life, replace the lamp (refer to 8.1).
Page 12 of 107
®
will repair or replace the product
(toll free)
(English)