Idiomas disponibles
Idiomas disponibles
4. Mounting / 5. Faults
Since the electrical connection is made of plastic, it is necessary to use a cable with the following shield connection:
Cables, connectors and terminating resistors which are used in a CAN network must comply with the
requirements of ISO 11898-2.
Pin assignment
→ For pin assignments, see product label.
→ The cable must be shielded and the shielding must be connected to pin 1 of the M12 connector.
5. Faults
CAUTION!
Physical injuries and damage to property and the environment
If faults cannot be eliminated by means of the listed measures, the pressure sensor must be taken out
of operation immediately.
▶
Ensure that pressure or signal is no longer present and protect against accidental commissioning.
▶
Contact the manufacturer.
▶
If a return is needed, please follow the instructions given in 7.2 "Return".
For contact details, see chapter 1 "General information" or the back page of the operating instructions.
In the event of any faults, first check whether the pressure sensor is mounted correctly, mechanically and electrically.
WIKA operating instructions pressure sensor, model MH-4-CAN
EN
9
