Idiomas disponibles
Idiomas disponibles
ENGLISH
8.3.
Electric Power Supply Connection
Connection must be carried out by authorised and
qualified
staff,
regarding the subject and using appropriate
prescribed material.
Before connecting the appliance to the
electric mains check that the voltage and the
frequency correspond to the data stated on the
registration plate applied on the rear of the
appliance.
GB
The appliance is supplied with an operating
voltage of 230V 1+N~ 50 50Hz. On request, it is
8.4.
Refrigerant Attachment (Prepared Models)
The "remote" condensing unit connection must be
carried out according to the attached refrigerator
lay-out.
Remember that the following are present in the
technical compartment:
Intake pipe.
Liquid delivery pipe.
These
are
corresponding types present in the condensing
unit.
8.5.
Inspection
The appliance is delivered in conditions that it can
be started-up by the user.
This functionality is guaranteed by passing the
tests (electric inspection - functional inspection,
9.
TECHNICAL NOTES
9.1.
Disposal of Evaporator Condensate
PREPARED MODELS
The elimination of the condensate produced
during the defrosting phase is performed manually
by intervening on the small tank positioned in the
lower part of the right compartment.
To empty, use the relevant handle, to act on the
collection tank with a
respecting
the
current
therefore
connected
with
possible
to
laws
voltages.
!
Before connection, ensure the presence of a
relevant differential switch with adequate power in
the mains power supply, upstream from the
appliance, in order to protect the appliance from
overloads or short circuits
When the connection has been made, carefully
empty and then load paying attention to use a
type of refrigerant gas that is compatible with the
components present.
For the start-up of the appliance, carry out electric
connections between the instruments
present on the control panel and condenser unit
according to the attached wiring diagram.
the
appearance inspection) and relative certification
through the specific attachments.
forward movement until it is completely extracted.
MOTORISED MODELS
The elimination of the condensate produced
during
the
AUTOMATICALLY and therefore does not require
any manual operation.
12
have
appliances
with
defrosting
phase
takes
different
place
