Idiomas disponibles
Idiomas disponibles
Connecting eStore
8.4
Connecting the power cable
A
NOTICE!
Only connect devices with a rated voltage of 12 Vg.
Pay attention to the correct polarity when connecting devices
to eStore. Please refer to the respective manual.
Make sure that the devices you want to connect are turned off.
➤ Turn off (open) the main switch of eStore one by pressing the main switch
command (fig. 1 1, page 3).
➤ Open the cover (see chapter "Opening the cover of the pole" on page 15) .
➤ Connect the positive cable to the positive pole (fig. 2 3, page 3).
➤ Tighten the terminal screw with a tightening torque of 13 to 15 Nm.
➤ Close the cover (see chapter "Closing the cover of the pole" on page 15.
➤ Open the cover of the negative pole (see chapter "Opening the cover of
the pole" on page 15) .
➤ Connect the negative cable to the negative pole (fig. 2 1, page 3).
➤ Tighten the terminal screw with a tightening torque of 13 to 15 Nm.
➤ Close the cover of the negative pole (see chapter "Closing the cover of
the pole" on page 15).
➤ Turn on (close) the main switch of the eStore by pressing the main switch
command (fig. 1 1, page 3).
8.5
Connecting consumers
➤ Turn off all devices, especially those that are connected with eStore.
➤ Turn off (open) the main switch of eStore one by pressing the main switch
command (fig. 1 1, page 3).
➤ Connect the 12 Vg device to eStore.
➤ Turn on (close) the main switch of the eStore by pressing the main switch
command (fig. 1 1, page 3).
➤ Turn on the 12 Vg device.
16
eStore
EN
