Virutex FC116U Manual De Instrucciones página 28

A
B
A
C
(Figure 19)
centro caja cerradura
H
G
centro caja cerradura
(Figure 20)
1640148
28 - FC116U / Operating instructions
"c"
"c"
"c"
centro caja cerradura
"c"
"c"
"c"
1640149
13. DRILLING THE HOLES FOR THE HANDLE AND KEY
• Lastly, with the help of template UT16I supplied with the ma-
chine, you can carry out the drilling necessary to attach the lock,
such as the holes for the handle, the chain lock, the key cylinder,
etc.
ASSEMBLING THE TOOL FOR THE UC16I
TEMPLATE
• Introduce a removable height bar from the
equipment inside the holes "A" and slide the
tool until the reference mark "0" is over the
centre "c" of the box for the lock (Fig. 19).
• Fix using knob B while at the same time
levelling the inside face C of the reference
plate on the edge of the door. (Fig. 19).
POSITIONING THE TOOL AND DRILLING
• Slacken bushing guide "G" and slide it in
a horizontal direction, placing index "H" at
measurement "D", and retighten it. (Fig. 20).
• Using the centre of the mortise as a refe-
rence, slide the tool vertically, to position it
at measurement "E" or "F", as desired. (Fig.
20).
• Once the hole position has been chosen,
drill using a bit Ø 11 mm.
• The second hole needed for the lock can
be made by using again the centre "c" of the
mortise as a reference.
OPTIONAL DRILLING TOOLS
1640148 Enlargement bit D.18 f/guide 11
1640149 Enlargement bit D.23 f/guide 11