Virutex FC116U Manual De Instrucciones página 20

E
(Figure 2)
Z
Y
N
(Figure 4)
20 - FC116U / Operating instructions
6. MOUNTING THE CUTTING TOOL
• The mortising trimmer is supplied with a 16 mm diameter bit
F
mounted on the end of the spline shaft.
To change the bit, lock the spline shaft by its planes with key "E"
(Fig. 2), unscrew the bit "G" with key "F" and replace with one of
G
the required diameter.
7. SWITCH
• Cut-out box (Fig. 3) is equipped with lever "Y" for starting up
the machine and lateral fixing stop "Z". To start it up, activate
fixing stop "Z" and, without releasing it, push forward lever "Y",
thus keeping the machine running.
When lever "Y" is pushed forward with the machine running,
stop "Z" loosens automatically and the machine comes to a halt.
The switch's fixing stop "Z" prevents the machine from starting
up accidentally.
(Figure 3)
8. ADJUSTING THE TRIMMING WIDTH
• Measure the widest point, "N", of the lock box, including any
protuberance it may have (Fig. 4). DO NOT INCLUDE the exterior
decorative face of the lock.
• Place a mortising trimmer bit of the measurement taken or
slightly larger, according to the instructions in section 6.
Check that the trimmer is disconnected from the
mains.
Check that the trimmer is disconnected from the
mains.