Idiomas disponibles
Idiomas disponibles
MAINTENANCE AND REPAIR INSTRUCTIONS
9. Once the spool is in place, apply pressure on the
spool that is compressing the spring. Pull each end
of the line sharply to unlock the line from the slots
(Fig. 18).
10. Continue to apply pressure to the spool until the
knob can be threaded clockwise onto the spindle.
Tighten the knob securely by hand (do not use any
other instrument) (Fig. 19).
11. Trim the excess line to about 5 in (13 cm). This will
minimize the load on the engine when it starts and
warms up.
12
Cutting
Line Ends
Fig. 18
Fig. 19
AIR FILTER
CAUTION:
filter. The air filter must be kept clean. If it
becomes damaged, install a new filter
To clean the air filter:
1. Remove the 2 screws holding air filter cover in place
(Fig. 20.
2. Remove the cover and lift the filter from the air box
(Fig. 21).
3. Wash the air filter in soap and water. DO NOT USE
GASOLINE!
4. Air dry filter.
5. Reinstall the filter, cover and screws.
NOTE: Replace filter if frayed, torn, damaged or unable
to be cleaned.
Never operate the
unit without the air
Screws
Cover
Fig. 20
Air Filter
Fig. 21
