Idiomas disponibles
Idiomas disponibles
Installation Instructions
3
7
7
4
V, W
X4, X6, X8
6
1
X4, X6, X8
6
1
8
X4, X6,
9
X8
INSTALL BRACKETS TO DISPLAY
1.
Lay display face down on protective surface.
2 5
CAUTION:
may damage your display! Proper screws will easily
thread into display mounting holes.
(S, U)
3
2.
Select screw diameter by examining hardware
bags "A" through "D" (8mm, 6mm, 5mm, or 4mm)
and comparing with mounting holes on display.
(R, T)
3
3.
Select washers:
•
6mm and 8mm diameter screws: Use flat
washer (U) and shoulder washer (T).
•
4mm and 5mm diameter screws: Use flat
washer (S) and shoulder washer (R).
4.
Select spacers:
•
If mounting holes are not recessed, and both
brackets (A and B) can lay flat against display,
then no spacers are required.
•
If mounting holes are recessed, or if
protrusions prevent brackets (A and B) from
laying flat, then spacers (V or W) must be
used. Select shortest spacer which will
provide adequate fill. All spacers must be
same length.
2 5
CAUTION:
damage your display! Proper screws will have
adequate thread engagement without contacting
bottom of display mounting holes.
(S, U)
3
5.
Select screw length:
(R, T)
3
•
Using your hand, insert SHORTEST length
screw of selected diameter (E, H, K, or N)
through bracket (A or B), selected flat washer
(S or U), selected shoulder washer (R or T),
selected spacer (V or W, if required), into
display mounting hole. Do NOT thread screw
into hole at this time.
•
Proper screw length requires base of screw
head to protrude above flat washer a distance
equal to or greater than the screw diameter. If
screw length is inadequate, select longer
screw. Select shortest screw which will
protrude the required distance.
(A, B) X2
6.
Place brackets (A and B) on display. Ensure pitch
adjustment knobs are towards outside of display,
and upper hooks are towards top of display.
7.
Using Phillips screwdriver, carefully install selected
screws through flat washers, shoulder washers,
brackets, and spacers (if required), into display. Do
not tighten screws at this time.
8.
Vertically center brackets (A and B) on display.
9.
Tighten all screws. Ensure all applicable display
mounting holes (4, 6, or 8) are used.
Using screws of improper diameter
Using screws of improper length may
iCMPTM1
11
