Idiomas disponibles
Idiomas disponibles
iCMPTM1
2
3
B
3
A
10
2
4
B
4
A
BRACKET MODIFICATION
In the shipped configuration, brackets (A and B) will
accommodate a display mounting hole pattern up to
16-3/8" (415mm) wide. If necessary, the brackets can
be modified to accommodate a display mounting hole
pattern up to approximately 18-1/2" (470mm) wide by
performing the following steps:
1.
Lay display face down on protective surface.
2.
Measure to ensure 16-3/8" (415mm) to
approximately 18-1/2" (470mm) mounting hole
width.
1
NOTE:
If width is 16-3/8" (415mm) or less, then no
modification is necessary.
3.
While holding bracket horizontal (to prevent
misalignment of washers), loosen and remove
pitch adjustment knob and carriage bolt.
4.
Reinstall pitch adjustment knob and carriage bolt
into opposite side of bracket.
Installation Instructions
