Zipper ZI-MD500HST Instrucciones De Servicio página 41

Waste oils are toxic and must not be released into the environment!
Contact your local authorities for information on proper disposal.
If you remove the oil level plug and no oil flows out, please add oil and then screw the oil level plug.
NOTE:
recommended motor oil: GL-5, GL-6, SAE80W-90. Do not use synthetic oil!
If you want to replace oil, place the machine on a level ground. The machine must be stopped and
still warm. Unscrew the filter cap and the drain plug. When the oil is drained, replace the drain plug,
fill up with fresh oil and then replace the filter cap.
14.5 Clutch
As clutch wears out, the same lever could have a wider opening, being so uneasy to use. To enable
proper operation, the clutch cable must be adjusted:
14.6 Steering
If you have difficulty steering the unit, you will need to adjust the steering levers with the special adjusters.
If the above adjustment does not create enough cable tension, follow the steps below:
ZIPPER MASCHINEN GmbH www.zipper-maschinen.at
N O TE
1. Loosen the jam nut (1) by turning it counter clockwise
with 10 mm wrench.
2. The clutch lever is set to the original position with the ad-
justing nut (2).
3. Then retighten the lock nut (1).
1. Loosen the jam nut (3) by turning it counter clockwise
with 10 mm wrench.
2. Unscrew the adjust nut (4) to eliminate the play in the ca-
ble, which can occur after initial use or normal wear. Be
very careful not to unscrew the adjust nut too much be-
cause this can create another problem: the loss of trac-
tion.
3. Then retighten the lock nut (3).
1. Loosen the jam nut (5) by turning it counter clockwise
with 10 mm wrench.
2. Unscrew the adjustment nut (6) to eliminate the play in
the cable. (do not to unscrew the adjust nut too much be-
cause this can create another problem: the loss of trac-
tion).
3. Retighten the lock nut (5).
MAINTENANCE
41
ZI-MD500HST