Zipper ZI-MD500HST Instrucciones De Servicio página 35

13 OPERATION
Device to be operated in a perfect state only. Inspect the device visually every time it is to be used. Check
in particular the safety equipment, controls and screwed connection for damage and if tightened
properly. Replace any damaged parts before operating the device.
13.1 Operating instructions
Disengage clutch lever before starting the engine
•
Always guide the unit with both hands
•
First engage, then accelerate
•
Do not overload the machine capacity
•
Always make certain that the weight is evenly balanced
•
Change the gears only when the machine stands still!
•
Go up slopes in one turn without stopping
•
Do not tipping on soft ground
•
Before start operating, check the dump box to make sure it is locked
•
Attention: While tipping the centre of gravity will change
•
13.2 Function of components
1 Engine switch: The engine switch must be in the ON position for the engine to run.
Turning the engine switch to the OFF position stops the engine.
ZIPPER MASCHINEN GmbH www.zipper-maschinen.at
• Mount the bracket (5) onto the snow blade
using 2 hex-bolts.
• Mount the Landing Leg weldment onto the
snow blade. Place the landing leg weldment
into the bracket and fix it with the hex bolt (6)
and nut (7).
• Install the already assembled snow blade on-
to the machine with the two delivered pins.
• The snow blade can be tilted in three posi-
tions:
- Straight position place bolt (1) in position
(Pos1).
- Tilt it to the right place bolt (1) in position
(Pos2).
- Tilt it to the right place bolt (1) in position
(Pos3).
N O TE
OPERATION
35
ZI-MD500HST