Idiomas disponibles
Idiomas disponibles
ENGLISH
Foam filter
Float in raised position
IMPORTANT: To reduce the risk of damage to
the vacuum, do not run motor with float in raised
position.
NOTICE:
WET PICK-UP ACCESSORIES SHOULD BE
WASHED PERIODICALLY, ESPECIALLY AFTER
PICKING UP WET,STICKY KITCHEN ACCIDENTS.
THIS CAN BE ACCOMPLISHED WITH A WARM
SOLUTION OF SOAP AND WATER.
EMPTYING THE TANK
WARNING: To reduce the risk of injury
from accidental starting, unplug power cord
before emptying the dust tank.
1. Remove the power head assembly of the
wet/dry vacuum by pulling outward on the lid
clips located on each side of the vacuum.
Lift off the power head assembly.
2. Dump the tank contents into the proper
waste disposal container.
FILTER REPLACEMENT
WARNING: To reduce the risk of injury
from accidental starting, unplug power cord
before changing or cleaning filter. The filter
should be cleaned frequently to maintain peak
vacuum performance.
WARNING: Do not remove filter cage and
float. The float prevents water from entering the
impeller and damaging the motor. The cage
prevents fingers from touching the moving impeller.
CAUTION: To avoid damage to the impeller
and motor, always reinstall the reusable filter
before using the vacuum for dry pickups and
always reinstall the foam filter before using the
vacuum for dry pickups and wet pickups.
CAUTION: After cleaning, check the filter
for tears or small holes. Do not use a filter with
holes or tears in it. Even a small hole can cause
dust to come out of the vacuum. Replace it
immediately.
CAUTION: Clean the filter in an open area.
CLEANING
To keep the wet/dry vacuum looking its best, use
a cloth dampened only with water and mild soap
to clean its surface.
To clean the tank:
1. Dump out debris.
2. Wash tank thoroughly with a cloth dampened
only with water and mild soap.
3. Wipe with dry cloth.
STORAGE
Before storing the vacuum, the dust tank should
be emptied and cleaned. The cord should be
wrapped and hung on the unit and the
accessories should be kept in the accessory
holder. The vacuum should be stored indoors.
TROUBLESHOOTING
Minor problems often can be fixed without calling
customer service.
PROBLEM
POSSIBLE CAUSE CORRECTIVE ACTION
Vacuum does
No electricity
not run
Loss of suction,
1. Full tank
wet pick-up
2. Clogged hose
3. Clogged filter
Loss of suction,
1. Full tank
dry pick-up
2. Clogged hose
3. Clogged filter
6
Make sure electrical
outlet has voltage (A
qualified electrician may
need to be contacted)
1. Drain and clean tank
2. Remove hose and clean
debris
3. Clean or replace filter
1. Drain and clean tank
2. Remove hose and clean
debris
3. Clean or replace filter
