Makita HR2631F Manual De Instrucciones página 9

Dust cup (optional accessory)
1
► 1. Dust cup
Use the dust cup to prevent dust from falling over the
tool and on yourself when performing overhead drilling
operations. Attach the dust cup to the bit as shown in
the figure. The size of bits which the dust cup can be
attached to is as follows.
Dust cup 5
Dust cup 9
There is another type of dust cup (optional accessory)
which helps you prevent dust from falling over the tool
and on yourself when performing overhead drilling
operations.
Installing or removing the dust cup
(optional accessory)
► 1. symbol 2. Grooves 3. Dust cup
Before installing the dust cup, remove the bit from the
tool if installed on the tool. Install the dust cup (optional
accessory) on the tool so that the
dust cup is aligned with the grooves in the tool.
Bit diameter
6 mm (1/4") - 14.5 mm (9/16")
12 mm (15/32") - 16 mm (5/8")
1
3
symbol on the
1
► 1. Bit 2. Chuck cover
To remove the dust cup, pull the chuck cover in the
direction as shown in the figure and with the chuck
cover pulled take the bit out of the tool.
► 1. Attachment at the foot of dust cup
And then grab the attachment at the foot of dust cup
2
and take it out.
► 1. Bellows 2. Attachment
9 ENGLISH
2
1
1
2